floss-jtag | The World of Esden

Hey everyone,

As you might know some time ago I have developed a small JTAG adapter based on the FT2232H chip. I gave it the name FLOSS-JTAG as the idea was that it should be absolutely OpenSource and OpenHardware.

You can find the project at GitHub and some more info at it’s random projects wiki page.

FLOSS-JTAG not only has the high speed 24MHz FT2232H chip (there are some designs based on my idea that are using a low speed version of the same chip). It provides the new standard 0.05″ pitch 10 pin Cortex JTAG header as well as a TTL level serial interface on it’s second interface.

I am glad to announce that I have reached the V1.0 with it. All necessary files to make your own are in the GitHub repository. But if you don’t want to go through the pains of ordering PCB, sourcing parts, assembling QFN SMD packages you can also purchase it in the Joby Robotics online shop.

At Joby Robotics you get a cable assembly to connect the FLOSS-JTAG to a target. This allows you to debug and connect to targets that are difficult to reach otherwise. You also will get a cortex connector to old standard 20pin 0.1″ pitch connector adapter.

The adapter is small and will make it also easier to debug targets that are difficult to reach.

You can get precrimped Molex Picoblade wires in 10 different colors at Joby Robotics too. This way you can easily build a UART cable that connects FLOSS-JTAG to a device.

I am very happy that FLOSS-JTAG is finally easily accessible to anyone who needs it.

FLOSS-JTAG works perfectly together with Openocd and Summon-ARM-Toolchain.

Cheers Esden

Because I wanted to have a small JTAG adapter with additional UART port and a different (smaller) connector then what is available out there, I have decided to make a JTAG adapter. I chose the FT2232 USB adapter chip. This guy is pretty nice because it has a special engine inside that is supporting many different protocols. One of them is JTAG. I have released what I made as always on GitHub under the CC-BY-SA 3.0 license. There is no software needed on the adapter side so no software included. All you need is OpenOCD. It now even has a config file dedicated for Floss-JTAG. Calling for example:

#> openocd -f interface/flossjtag.cfg -f board/open-bldc.cfg

will connect to Open-BLDC using the Floss-JTAG adapter.

Building Floss-JTAG I learned a nice lesson. Always check your footprints 10x before you send the gerber files to the manufacturer!!! I had to customize the footprint for the FT2232 chip and made a mistake. The pads were not long enough so the pins had only 0.1mm overlap area. It was a real pain to solder that. I assembled 3 of Floss-JTAG using this design. Sadly only two are working.

Because of that mistake I immediately corrected the board layout and sent it out. I got the boards today. I hope that there is no other mistake hidden somewhere. 🙂 Attached are the images of V0.1 assembly and of the V0.2 boards.